High Voltage
In the top 97% of Urban's most interesting posters
I'll describe it (unless a u-shaped screwdriver is what I'm really looking for)
Start off with a flat blade screw driver with the end "around" 11-12mm
Then cut out the middle 8mm'ish - leaving 2 x 1.5-2mm prongs
The bit you've cut out goes up into the blade by about 2mm
This is needed for removing a locking ring which is used to locate a plug-in power source for a frighteningly expensive colour viewer - if you look at the picture below you can "just" make out where the power recharger plug-in - that's the locking ring which I need to remove to change over the battery pack and lighting system
Thank you in anticipation
Start off with a flat blade screw driver with the end "around" 11-12mm
Then cut out the middle 8mm'ish - leaving 2 x 1.5-2mm prongs
The bit you've cut out goes up into the blade by about 2mm
This is needed for removing a locking ring which is used to locate a plug-in power source for a frighteningly expensive colour viewer - if you look at the picture below you can "just" make out where the power recharger plug-in - that's the locking ring which I need to remove to change over the battery pack and lighting system
Thank you in anticipation